Skip to main content

Configuring Cisco SPA122/SPA8000 ATA

Alex
Updated

This procedure describes how to manually reconfigure a Cisco SPA122 ATA device to work on the BroadSoft BroadCloud network. Once this procedure has been completed, and prior configuration settings on the device will be overridden, including the administrator password, and the device will only be usable on the BroadSoft BroadCloud network. The device must be returned to factory default configuration before it can be used on any other network.

Cisco SPA122:

  1. Ensure the Cisco SPA122 has been factory defaulted
  2. Connect a PC to the SPA122 Ethernet (yellow) port, then power on your PC
  3. Open a web browser and enter 192.168.15.1 in the address bar
  4. To log in enter admin as the user and admin as the password
  5. Click the Voice tab
  6. Click the Provisioning tab
  7. Enter the following link in Profile Rule: http://myportal.saddlebackcomm.com/sip-ps/$MA.cfg
  8. Select Submit All Changes at the bottom of the page
  9. When the GUI returns, select the Administration tab
  10. Click the Reboot tab
  11. Click the Reboot button
  12. Click OK in the popup confirming the reboot
  13. Wait 5-10 minutes for the new configuration to download

Note: When configured on the BroadSoft BroadCloud PBX Network the Yellow Ethernet port on the SPA122 is supported in bridge mode as a switch port. This port will not supported as a home router. If devices inside the office (such as a printer or computer) were connected to this port they will be able to properly communicate with other devices on the customers’ LAN. It must be noted that anytime the SPA122 is powered off or rebooting, this switch port will be down.

For additional configuration options reference the Cisco Administration Guide

Cisco SPA8000:

  1. Connect an analog phone into line one of the device
  2. Press the start key four times ****
  3. Press 110# and record the IP address
  4. From a browser on the same LAN, enter the IP address recorded in step 3
    1. If prompted for a user and password, enter it now. Then click admin and enter the admin user and password.
    2. For 2102 only. If the browser does not take you to the SPA webpage, you must activate the web utility. Redo step 2 and then enter 7932#, 1# 1
  5. Click the admin link in the top right of the page
  6. Click the advanced link in the top right of the page
  7. Click the Voice tab
  8. Click the Provisioning tab
  9. Enter the following link in Profile Rule: http://myportal.saddlebackcomm.com/sip-ps/$MA.cfg
    1. If you are having trouble flashing your device with these URLs, please create a support ticket for assistance.
  10. Select Submit All Changes at the bottom of the page
  11. When the GUI returns, cycle power on the SPA.
  12. Wait 5 minutes for the new configuration to download

Once the second boot process has completed, the device will be provisioned for use in the BroadSoft Cloud network. If the station assignment process was properly completed prior to the reboot, the device will boot into a station specific assigned/usable state. If not, the device will boot into a default Cisco SPA122 unassigned/unusable state, and will remain in this state until the site administrator has completed the station assignment process. If this occurs, contact your site administrator and request that station assignment be completed for the device in question.

 

Comments

0 comments

Article is closed for comments.